Dometic 630025 Instructions d'exploitation Page 80
- Page / 134
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
80
6F.DC VOLT REQUIREMENTS
DC VOLTSDC VOLTS
DC VOLTSDC VOLTS
DC VOLTS
On models 391XX.XXX, a DC volt supply is supplied to the
thermostat location: Positive (+) DC volt wires to R terminal
on the thermostat; and negative (–) DC volt wires to the
black wire from the unit. Polarity is crucial for proper
operation.
The operating range is 10 to 16 volts DC.
7F.COMPONENTS
THERMOSTATTHERMOSTAT
THERMOSTATTHERMOSTAT
THERMOSTAT
A.A.
A.A.
A.
MODEL 39015.601 and 39025.501MODEL 39015.601 and 39025.501
MODEL 39015.601 and 39025.501MODEL 39015.601 and 39025.501
MODEL 39015.601 and 39025.501
Two thermostats were used on these models: a cooling
only thermostat and a heating and cooling thermostat. Both
are 24V AC controlled systems.
On the base of the
cooling only thermostacooling only thermosta
cooling only thermostacooling only thermosta
cooling only thermostat, the is a FAN
switch with two positions, AUTO and ON. This operates the
air conditioner only. A separate thermostat is needed for
the furnace.
Verify that the thermostat wiring is correct.
A three connector cable 19 to 22 AWG is to be used for low
voltage connections. Low voltage wires in the control
compartment are marked "R", "G" and "Y". Route low
voltage cable from thermostat to unit electrical box.
Connect "R" from thermostat to red wire in control compart-
ment. Connect "G" from thermostat to blue wire in control
box. Connect "Y" from thermostat to yellow wire in control
box. Use wire nuts to ensure good connections.
To check the thermostat, be sure the OFF switch is all the
way to the right side. Next, disconnect all three wires at the
terminals R, G and Y.
Next, using an ohmmeter, check for continuity between R
and G and/or Y in the following manner. With room tem-
perature above the set point temperature and FAN switch
in AUTO position, continuity should exist between R to Y
and R to G. With room temperature below the set point and
FAN switch AUTO position, no continuity should exist
between R to Y and R to G.
With FAN switch to ON position, continuity should exist
between R to G regardless of room temperature.
To check ACTIVE terminals, place one lead from ohm
meter to R terminal and the other lead to the ACTIVE
terminal.
SWITCHSWITCH
SWITCHSWITCH
SWITCH
COMBINATIONCOMBINATION
COMBINATIONCOMBINATION
COMBINATION
IF ROOM TEMP.IF ROOM TEMP.
IF ROOM TEMP.IF ROOM TEMP.
IF ROOM TEMP.
IS ABOVE/BELOWIS ABOVE/BELOW
IS ABOVE/BELOWIS ABOVE/BELOW
IS ABOVE/BELOW
SetpointSetpoint
SetpointSetpoint
Setpoint
TEMP.:TEMP.:
TEMP.:TEMP.:
TEMP.:
FANFAN
FANFAN
FAN
SWITCHSWITCH
SWITCHSWITCH
SWITCH
AUTOAUTO
AUTOAUTO
AUTO
ONON
ONON
ON
TERMINALS THATTERMINALS THAT
TERMINALS THATTERMINALS THAT
TERMINALS THAT
ARE "ON"ARE "ON"
ARE "ON"ARE "ON"
ARE "ON"
G YG Y
G YG Y
G Y
ABOVEABOVE
ABOVEABOVE
ABOVE
XX
XX
X
XX
XX
X
BELOWBELOW
BELOWBELOW
BELOW
ABOVEABOVE
ABOVEABOVE
ABOVE
XX
XX
X
XX
XX
X
BELOWBELOW
BELOWBELOW
BELOW
XX
XX
X
COOLING ONLY THERMOSTATCOOLING ONLY THERMOSTAT
COOLING ONLY THERMOSTATCOOLING ONLY THERMOSTAT
COOLING ONLY THERMOSTAT
(FRONT)(FRONT)
(FRONT)(FRONT)
(FRONT)
COOLING ONLY THERMOSTATCOOLING ONLY THERMOSTAT
COOLING ONLY THERMOSTATCOOLING ONLY THERMOSTAT
COOLING ONLY THERMOSTAT
(BACK)(BACK)
(BACK)(BACK)
(BACK)
- BASEMENT (SINGLE COMPRESSOR) 5
- HEAT PUMP SECTION: 5
- BASEMENT (DUAL COMPRESSOR) 7
- AIR CONDITIONER SECTION: 7
- Continued 10
- MODEL 390XX.XXX SECTION 14
- MODEL 391XX.XXX SECTION 15
- MODELS 393XX.XXX SECTION 16
- MODEL 39224.601 SECTION 18
- MODEL 39424.601 SECTION 19
- DUO-THERM AIR CONDITIONERS 21
- PROPER THERMOSTAT 24
- LOCATION 24
- 1, 3, 4 Near Heat Sources 25
- 2 Near Drafts or Heat source 25
- 5, 6 Near Drafts 25
- 7 On an Outside Wall 25
- 2B. DC VOLT REQUIREMENTS 26
- 4B. WIRING 26
- HEAT PUMP 27
- 3105024.008 30
- 13B. TYPICAL WIRING DIAGRAM 31
- FOR MODELS 390XX.XXX 31
- 14B. TYPICAL WIRING DIAGRAM 31
- FOR MODELS 391XX.XXX 31
- 1C. BLOWER MOTOR 34
- 2C. RUN CAPACITOR 35
- 3C. START CAPACITOR 35
- 5C.COMPRESSOR 36
- 6C. OVERLOAD PROTECTOR 37
- 7C. COLD (FREEZE) CONTROL 37
- 8C. HEATER 37
- 9C. SHORT CYCLE 38
- 10C. AIR FLOW OBSTRUCTION 38
- 11C. AIR DISTRIBUTION SYSTEM 38
- REGISTERS 39
- INDOOR SECTION 41
- GRILLS AND REGISTERS: 41
- C. BASEMENT UNITS 42
- MODELS 39224 AND 39424 42
- EVAPORATION SECTION 43
- 12C. OTHER 44
- 13C. SEALED SYSTEM 45
- CYLINDER 46
- 14C. SEALED SYSTEM PROBLEMS 47
- PRE-WIRED F OR OPT. HEAT 49
- TEMPERATURE SL IDE SET 50
- AT 70 DEGREES 50
- 4D. DC VOLTAGE REQUIREMENTS 53
- 5D. COMPONENTS 53
- ARROW F OR 55
- AC W HITE 56
- TO A .C. W HITE 57
- E. OPERATION 58
- 1E. THE COOLING MODE 58
- 2E. THE HEATING MODE: 58
- 3E. GENERAL INFORMATION 59
- 4E. MECHANICAL CONTROLS 60
- 5E. ELECTRONIC (DIGITAL) 60
- CONTROLS 60
- 6E. BIMETAL CONTROLS 62
- 7E. DC VOLT REQUIREMENTS 63
- COMPONENTS 63
- 8E. SELECTOR SWITCH 63
- 9E. THERMOSTAT 64
- HEAT PUMPAUX HEAT 67
- CABLE ASSEMBLY CONNECTOR 68
- 11E. CHANGEOVER THERMOSTAT 71
- 12E. RELAY BOARD 71
- RELAY BOARDRELAY BOARD 72
- RELAY BOARD 72
- 14E. REVERSING VALVE 73
- 15E. RELAY, FAN SPEED (DPST) 73
- & HEAT PUMPS 74
- DIGITAL THERMOSTAT OPERATION 75
- 4F. MODEL 39224.601 76
- THERMOSTAT:THERMOSTAT: 77
- THERMOSTAT: 77
- ADJUSTING Setpoint 79
- 6F.DC VOLT REQUIREMENTS 80
- 7F.COMPONENTS 80
- THERMOSTATTHERMOSTAT 85
- THERMOSTAT 85
- Y1 Y2 GL GH W 86
- THERMOSTAT CONNECTIONS 87
- 8F. CABLE ASSEMBLY 94
- 9F. REVERSING VALVE 95
- 10F. TRANSFORMER 96
- 11F. RELAY BOARD 96
- 13F. CHANGEOVER THERMOSTAT 96
- 13F. TIME DELAY RELAY 97
- 14F. RELAY 97
- OPERATION 100
- GENERAL INFORMATION 101
- C. HEAT PUMP OPERATION 102
- D. FURNACE MODE OPERATION 102
- J. STAGE CONTROL OPERATION 104
- K. AUX. HEAT 105
- M. RESET 105
- A. ONE COMFORT ZONE 106
- 2G. CONFIGURATION 106
- B. TWO COMFORT ZONES 114
- C. THREE COMFORT ZONES 126
- D. FOUR COMFORT ZONES 126
- 3G. DC VOLT REQUIREMENTS 127
- 4G. COMPONENTS 127
- 2. CABLE ASSEMBLY 128
- 4. AMBIENT SENSOR 129
- 5. REMOTE SENSOR 129
- 3. RELAY, 2-POLE 129
- 6.AC POWER MODULE BOARD 130
- 8. ELECTRIC HEATER ASSEMBLY 133
- 9. RELAY 9T91/120V) 133
Produits connexes et manuels pour Pompes à chaleur Dometic 630025
(12 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.195 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels