Dometic RH449LDBI Manuel d'utilisateur télécharger pdf (Page 5)

3. Cleaning

Clean the refrigerator thoroughly at intervals, as

necessary. Remove the shelves; these, parts,

as well as the cabinet interior and the door should be

washed with a warm solution of sodium bi-carbonate.

Finally wipe over with a cloth rinsed in warm water

only, and dry with a clean cloth. Do not wash any

plastic parts in water that is more than hand warm, and

do not expose them to dry heat. The outside of the

cabinet should be wiped down regularly with a clean,

damp cloth.

NEVER USE STRONG CHEMICALS OR ABRASIVE

CLEANING MATERIALS ON ANY PART OF THE

CABINET.

4. Positioning the appliance

When first using this refrigerator please consider the

following points:

ENSURE REFRIGERATOR IS LEVEL

THE PIPEWORK AT THE BACK GETS HOT IN USE

THE REFRIGERATOR HAS NO 'MOTOR' AND IS

THEREFORE VIRTUALLY SILENT

ALLOW AT LEAST 3 HRS. FOR SIGNS OF

COOLING

During the refrigeration process, the appliance

gives off heat from the condenser (under the

upper part of the rear cover) into the surrounding air.

The more ventilated the condenser is, the more

effective the refrigeration will be.

The other condition for satisfactory operation is that

the appliance is levelled. This could be checked by

placing a glass of water on top of the appliance.

It is important that the appliance is not directly

exposed to radiated heat (sunlight, radiator, near an

oven, etc.).

4.1. Installation instructions

The refrigerator is equipped with an electrically heated

absorption cooling unit which is virtually silent in

operation. The fridge is designed for free-standing

installation, but can be built-in if the following

conditions are complied with to ensure satisfactory

operation and maximum cooling efficiency.

4.1.1. Built-in version

This version is planned for building-in purposes. The

miniBar can be screwed to the furniture using the

fittings at the bottom. Drive in the screws (figure 2).

Difference between pivot points can be equalized with

the help of the sliding hinge, which is a standard

accessory for this version. The hinge recommended

to fix onto the top third of the refrigerator's door.

Please make sure before final fixing that the flat sliding

part allows normal door opening in order to avoid door

sticking (figure 2).

At the building-in process please take into

consideration the items listed below.

Figure 2.

IMPORTANT

Please follow the installation details below

carefully. Guarantee is valid for products

installed as described only.

1. The refrigerator must be le

vel both

directions

2. There should be 20 mm clearance to the wall

3. Ventilation must be provided as shown in

alternatives A, B, C or D (fig. 3-4)

Figure 3.

4. The ventilation duct must at least measure

105 mm x the width of the refrigerator

5. Only

the entire cooling unit must project into

the duct as shown

6. Air passing thr

ough the duct must not be

preheated by any source of heat

7. Ventilation grills, if used, must have an free

openings of at leas

t 200 cm² each

miniCool

Air in

Air out

Ventilation grille

Air out

Air in

miniCool

miniBar

1 2 3 4 5 6 7 8 9 10 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Dometic RH449LDBI Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Glacières Dometic RH449LDBI