Dometic RH449LDBI Manuel d'utilisateur télécharger pdf (Page 7)

Figure 6.

9. Reversing the door hang (Fig. 7.)

Reversing is suggested to perform in the following

way, in order to avoid breaking of the hinge bolt:

Figure 7.

Disconnect the mains

Lay the appliance down carefully on its back

Take down the two foot-extension (1) pieces by

removing the two screws (2)

Remove the four screws (4) and take out the two

fixing feet (3)

Remove the four screws (7) the upper hing (5) and

the cover cap (6)

Remove the door (8), together with the upper hinge

(5), from the housing

Insert the upper hinge (attached the miniBar)

and the covering plate in the slot on the opposite

side and secure with four screws (7).

Insert the door on the upper hinge and place it.

Mount the fixing feet (3) with hinge bolts (9)

placed into the opposite side of the feet

Mount the two foot-extension pieces (1)

Check that the door closes easily and is sealed

properly.

10. Replacing the decorative

door panel (Fig. 7., 8.)

(only free-standing model)

Removing and mounting of the door is similar to

that of described in the previous, 9 chapter. (Only

the foot on the hinge-side has to be removed!)

Remove screws (4) and pull off the frame edge (5).

Slide the decorative panel (6) out of the door frame

and insert the new panel (7), so that the upper edge

of the panel runs exactly parallel to the upper edge of

the frame. A new panel can be inserted more easily

into the upper edge of the frame when the two

corners are cut off by approx. 5 x 5 mm (8). Put the

frame edge (5) back in place and secure with screws.

Place the door on the lower hinge (9), slot the

upper hinge into the opening, press together with

the door against the housing and secure with the

two screws (11).

Figure 8.

11. Customer service

Before you call a service engineer, carry out the

following simple tests:

Problem

The appliance does not cool sufficiently

The appliance does not cool at all.

Possible cause

Too much food to be cooled was put in.

Door is not shut properly.

Internal air circulation is restricted.

Refrigerator not level.

Plug is not connected to the mains socket

properly

There is no voltage in the mains socket.

Solution

Put in less food to be be cooled.

Check if the door is shut.

Provide inside cool air circulation.

Level refrigerator.

Check if the connection is

proper.

Check if there is voltage.

If after checking all the above points, the refrigerator is

still not working satisfactorily, contact your nearest

service engineer. State the problem, model, product-

and serial-number.

(Details of the model, product- and serial-number are

to be found on the data label in the top left of the

inside compartment.)

This refrigerator is equipped with overheating

protection.

An authorised service technician can check

whether this has beentriggered or not.

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Dometic RH449LDBI Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Glacières Dometic RH449LDBI