Dometic RM2193 Manuel d'utilisateur télécharger pdf (Page 7)

Gas operation

After initial installation, servicing, or changing gas cylinders, etc., the gas line may

contain some air which should be allowed to escape by briefly turning on the refrige

rator or other gas appliances. This will ensure that the flame lights immediately. See

FIG. 1 for control location and identification.

1) Open the shutoff valve of the gas bottle. Check that there is enough gas. Open any

on-board shutoff valve which is in the gas line to the refrigerator.

2) Open the lower vent at the rear of the refrigerator on the outside of the vehicle, and

switch the electrical toggle switch/es (A in RM2191) and (A and E in RM2193) to the

"OFF" position.

3) Turn the gas thermostat control (B) to the highest setting.

4) Depress the knob (B) of the flame failure device, and hold it down while depressing

the piezo igniter button (C) several times in quick succession (a click should be heard

each time it is depressed).

5) Keep the knob depressed for a further 10-15 seconds.

6) Release the knob and check for flame by looking through the opening in the metal

burner cover.

7) If the burner has not lit, repeat the lighting procedure. If the burner fails to light wit

hin a couple of attempts, contact a qualified technician or your dealer.

NOTE: The refrigerator has a flame failure device which will automatically shut

off the gas to the burner if the flame is blown out. While the knob (B) is being

held in, this device is temporarily inoperative.

8) To terminate gas operation, turn knob (B) to the "OFF" position.

DO NOT attempt to operate the refrigerator by both gas and electricity at the same time.

Always ensure that one method of operation is turned off before using the alternate

energy source.

Electrical operation

1. RM 2191: DC OPERATION

On 12V DC operation, the temperature is controlled by a thermostat. The thermostat

knob (D, in FIG. 1) should be set to position 4-5 in normal working conditions.

If the ambient temperature is high and/or fresh food is put into the refrigerator you

may set the refrigerator to a higher position.

If you wish a higher temperature in the cooling compartment, set the knob to a lower

position.

2. RM 2193: 12V DC / 230V AC OPERATION

In the case of the RM2193, the refrigerator works continuously on DC operation (no

thermostat control).

On AC operation, the temperature is controlled by a thermostat. The thermostat knob

(D, in FIG. 1) should be set to position 4-5 in normal working conditions. If the ambient

temperature is high and/or fresh food is put into the refrigerator you may set the refri-

gerator to a higher setting.

If you wish a higher temperature in the cooling compartment, set the knob to a lower

position.

3. To TERMINATE ELECTRIC OPERATION

To terminate electric operation, turn the switch/es to the "OFF" position (A in RM2191)

and (A and E in RM2193).

NOTE: NEVER OPERATE THE REFRIGERATOR ON MORE THAN ONE ENERGY SOURCE

AT A TIME.

5.2.3

5.2.4

1 2 3 4 5 6 7 8 9 10 11 12 ... 24 25

Commentaires sur ces manuels

Pas de commentaire

Dometic RM2193 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs-congélateurs Dometic RM2193