Dometic RM2193 Manuel d'utilisateur télécharger pdf (Page 17)

Installation

The refrigerator must be installed in a substantial enclosure and must be level.

When installing the refrigerator in the

enclosure, all areas within the recess in

which the refrigerator is installed must be

sealed from the living space.

Make sure that there is a complete seal

between the front frame of the refrigerator

and the top, sides and bottom of the enclo

sure. A length of sealing strip is applied to

the rear surface of the front frame for this

purpose (FIG.4).

The sealing should provide a complete iso

lation of the appliance's combustion

system from the vehicle interior.

Note: Be careful not to damage the sealing strip when refrigerator is put in place.

Securing the refrigerator in enclosure

The refrigerator is installed in the enclosure with eight screws. Six screws are in the

front frame and two are in the plate on the rear. See FIG. 5.

NOTE: Push refrigerator into enclo

sure until front frame is tight against

the cabinet. First, secure the frame

to cabinet with six screws. Second,

install the two screws to the floor at

the rear of the refrigerator.

Failure to follow the sequence in

securing the refrigerator in the

enclosure can cause leakage bet

ween the frame and cabinet. Any

space between the counter, storage

area or ceiling and top of the refri

gerator should be blocked. The heat

produced at the rear of the refrigerator will become trapped in this space, making the

top of the refrigerator hot and reducing the efficiency.

The dimensions shown in FIG. 3 will give you adequate space for service and proper

installation.

6.4

FIG. 4

FIG. 5

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Pas de commentaire

Dometic RM2193 Manuel d'utilisateur Page 17