Dometic RM2193 Manuel d'utilisateur télécharger pdf (Page 14)

Ventilation

The installation shall be made in such a manner as to separate the combustion system

from the living space of the mobile home or recreational vehicle. Ventilation grilles

must have a free cross section of 250 cm² for air supply or venting of fumes.

Proper installation requires one fresh air intake and one upper exhaust vent.

The ventilation kits shown in this instruction manual have been certified for use with the

refrigerator model listed in the Table. For "Certified Vent System Kits" see Section B.

The ventilation kits must be installed and used without modification. An opening toward

the outside at floor level in the refrigerator compartment must be provided for ventilation

of heavier-than-air fuel gases. The lower vent of the recommended kits is provided with

properly sized openings. The flow of combustion and ventilation air must not be

obstructed. The lower side vent is fitted with a panel which provides an adequate

access opening for ready serviceability of the burner and control manifold of the refri-

gerator. This should be centered on the back of the refrigerator.

Certified Installation

Certified installations require one upper side vent and one lower side vent.

For certified vent system kits, see sect. 6.2.3.

For further information, contact your dealer or distributor.

Method of Installation

The methods of installation are shown in FIG. 1 and FIG. 1a. It is essential that all maxi-

mum or minimum dimensions are strictly maintained as the performance of

the refrigerator is dependent on adequate flow of air over the rear of the refrigerator.

NOTE: The upper vent should be centered over the condenser coil at the back of

the refrigerator.

6.2

Fig. 1

Fig. 1a

6.2.1

6.2.2

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Pas de commentaire

Dometic RM2193 Manuel d'utilisateur Page 14