Dometic VT2500 Manuel d'utilisateur télécharger pdf (Page 5)

OPERATION

Putting into operation

First check whether:

 the cassette has been inserted correctly

 the vehicle water tank has been filled

 the power supply has been switched on (main switch).

Once the power supply for the vehicle has been switched on, the toilet is also auto-

matically switched on and a vacuum is produced in the system for the first time.

The yellow LED illuminates on the display panel.

After approx. 1 minute this procedure is finished. The green LED illuminates.

By lifting the pedal allow a little water to enter the toilet, so that the closure on

the base of the receptacle is covered.

Repeat this procedure after each flushing.

Display panel

If the cassette is full or it is removed, the red LED illuminates and the pump is

switched off.

It cannot be used further until the cassette has been emptied or it is

inserted again.

Flushing the toilet

The toilet may only be flushed whilst the green LED is illuminated.

To flush, press the pedal down on the left side of the toilet. During the

flushing process close the seat lid; this will considerably reduce the

noise.

In order to be able to use the toilet as often as possible for one cassette

filling, please economize on the water and paper. Normally approx. 0.4 L water

are sufficient for flushing once.

The system is ready for operation!

55..00

5.1

5.2

GELB (pump is running )

TOILET CANNOT BE USED

GREEN (ready

RED (Cassette full or cassette

removed)

TOILET CANNOT BE USED

LED

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Dometic VT2500 Manuel d'utilisateur Page 5