Dometic RM2451 Manuel d'utilisateur télécharger pdf (Page 7)

Replace the top decoration panel. Be careful not to pinch

the wires behind the panel.

Make sure the tabs snap back into the holes in the hinge

plate.

STEP 3: Two screws installed in the rear base.

See FIG. 10.

Failure to follow the sequence in securing the refrigerator

in the enclosure can cause leakage between the frame

and cabinet. Any space between the counter, storage

area or ceiling and top of the refrigerator greater than 1-

1/2 inches should be blocked. The heat produced at the

rear of the refrigerator will become trapped in this space,

making the top of the refrigerator hot and reduce the

efficiency of the refrigerator.

GAS CONNECTION

Hook up to the gas supply line is accomplished at the

manual gas valve, which is furnished with a 3/8" SAE

(UNF 5/8" -18) male flare connection. All completed con-

nections should be checked for leaks with soapy water.

FIG. 9

DO NOT use a flame to check for gas leaks.

The gas supply system must incorporate a pressure regu-

lator to maintain a supply pressure of not more than 11

inches water column.

When testing the gas supply system at test pressures in

excess of 1/2 psi, the refrigerator and its individual shutoff

valve must be disconnected from the gas supply piping

system.

When testing the gas supply system at pressures less

than or equal to 1/2 psi, the appliance must be isolated

from the gas supply piping system by closing its indi-

vidual manual shutoff valve.

In case detailed instructions on the installation and con-

nection to the gas supply are required, contact your

dealer or distributor.

TESTING LP GAS SAFETY SHUTOFF

The gas safety shutoff must be tested after the re-

frigerator is connected to the LP gas supply.

To test the gas safety shutoff, proceed as follows:

1. Start the refrigerator according to the instructions

without connecting to 120 volts AC.

2. Check that the gas flame is lit. In AUTO mode the

AUTO mode indicator lamp (A) is on.

3. Close the manual gas shutoff valve at the back of

the refrigerator. (See FIG. 1).

4. Wait for one minute. The CHECK indicator lamp

(B) should be on, and the flame extinguished.

5. Remove protection cover (see FIG. 1) and open

the manual gas shutoff valve. Do not change any

button position on the control panel. Apply a non-

corrosive commercial bubble solution to the burner

jet orifice.

6. No bubbles should appear at the opening of the

burner jet orifice. The presence of bubbles indi-

cates a defective gas safety shutoff, and service is

required.

7. If no bubbles were present at the burner jet orifice,

it should be rinsed with fresh water. Be careful not

to damage the burner jet orifice. Replace cover and

press the main power ON/OFF button (1) OFF and

back ON. Normal operation of the burner should

return. Allow the burner to operate for a minimum

of 5 minutes.

Drain water hose

A hole must be drilled through flooring see FIG. 10.

The installer MUST make sure that the hose does not

kink when run through the floor. Seal around the hose

that goes through the drilled hole. If a longer hose than

supplied is required to get the water to drain outside of

the vehicle, the installer will have to supply the extra

length of hose.

! WARNING

FIG. 10

Hole for drain water hose

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Dometic RM2451 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Non Dometic RM2451