Dometic RM2451 Manuel d'utilisateur télécharger pdf (Page 4)

INSTALLATION

GENERAL INSTRUCTION

This appliance is designed for storage of foods and

storage of frozen foods and making ice.

This appliance is certified under the latest edition of

ANSI Z21.19•CSA 1.4 Refrigerators using gas fuel.

The installation must conform with local codes, or in

absence of local codes, the following standards as ap-

plicable.

In the U.S. the installation must conform with:

1. National Fuel Gas Code, ANSI Z223.1/NFPA 54

(latest edition).

2. Recreational Vehicles Code, ANSI A119.2 (latest

edition)

3. Manufactured Home Construction and Safety

Standard, Title 24 CFR, Part 3280.

If an external electrical source is utilized, the refrigera-

tor, when installed, must be electrically grounded in ac-

cordance with local codes or, in the absence of local

codes, the National Electrical Code, ANSI/NFPA 70 - (lat-

est edition).

In CANADA, the installation must conform with:

1. Natural Gas and Propane Installation Code,

CSA B149.1

2. CSA Z240 RV Series, Recreational Vehicles.

3. Current CSA Z240.4, Gas-equipped Recreational

Vehicles and Mobile Housing.

If an external electrical source is utilized, the refrigera-

tor, when installed, must be electrically grounded in ac-

cordance with local codes or, in the absence of local

codes, the Canadian Electrical Code, CSA C22.1, Parts

I and II - (latest edition).

VENTILATION

The installation shall be made in such a manner as to

separate the combustion system from the living space

of the mobile home or recreational vehicle. Openings

for air supply or for venting of combustion products shall

have a minimum dimension of not less than 1/4 inch.

Proper installation requires one lower fresh air intake

and one upper exhaust vent. The ventilation kits shown

in this instruction manual have been certified for use

with the refrigerator models listed in the Table.

For “Certified Vent System Kits” see page 15.

The ventilation kits must be installed and used without

modification. An opening toward the outside at floor level

in the refrigerator compartment must be provided for

ventilation of heavier-than-air fuel gases. The lower vent

of the recommended kits is provided with proper size

openings. The flow of combustion and ventilating air must

not be obstructed.

The lower side vent is fitted with a panel, which provides

an adequate access opening for ready serviceability of

the burner and control manifold of the refrigerator. This

should be centered on the back of the refrigerator.

CERTIFIED INSTALLATION

Certified installations require one roof vent and one lower

side vent.

For “Certified Vent System Kits” see page 15.

For further information contact your dealer or

distributor.

METHODS OF INSTALLATION

The method of installation is shown in FIG. 3.

It is essential that all maximum or minimum dimensions

are strictly maintained, as the performance of the refrig-

erator is dependent on adequate flow of air over the rear

of the refrigerator.

FIG. 3

Minimum

ventilation

height

Condenser

NOTE: The upper vent should be

centered over the condenser coil

at the back of the refrigerator.

1 2 3 4 5 6 7 8 9 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Dometic RM2451 Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Non Dometic RM2451