Dometic 10 Manuel d'utilisateur télécharger pdf (Page 9)

Hi - (HIGH): The fan operates continuously at high speed. The com-

pressor cycles ON and OFF.

Au - (AUTO): When auto fan is selected the fan speed will vary

depending on the difference between the temperature set-point and

the room air temperature. In auto fan the compressor and the fan

will cycle On and Off with the thermostat. See “Special Features”

on page 11 for information on auto fan.

“Furnace” - Furnace Mode

In this mode there are 3 fan speed selections:

Lo - (LOW): The fan operates continuously at low speed.

Hi - (HIGH): The fan operates continuously at high speed.

Au - (AUTO): The fan will be OFF.

Note: If additional indoor air circulation provided by the air condi-

tioner is not desired during Furnace Mode of operation, select Au

(AUTO) in the Fan Mode to shut the air conditioner fan off. If Lo

(LOW)orHi(HIGH)isselectedtheairconditionerfanwillcontinue

to operate on the selected speed.

In the FURNACE mode the system will cycle the RV’s furnace On

and Off based on the room air temperature and the temperature

set-point on the Single Zone LCD thermostat. The system can be

conguredtooperateusinganOn/Offdifferentialofeither1degree

F or 2 degree F. This feature is programmed during the system ini-

tialization. See “System Initialization” on page 3.

To set the temperature differential the system must be Off. Press

the“―” button and, while holding it, also press and hold the On/Off

Mode button for three seconds. Release the On/Off Mode button.

Then release the “―”button.Pressthe“+” button to toggle between

“d1”and“d2”, “d1” for 1 degree F differential and “d2” for 2 de-

grees F differential.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Dometic 10 Manuel d'utilisateur Page 9