Dometic NDA1402 Manuel d'utilisateur télécharger pdf (Page 5)

INSTALLING REFRIGERATOR IN

ENCLOSURE

Securing the Refrigerator

After the refrigerator is put in place, (ensuring a com-

bustion seal at the front frame), the refrigerator is to be

secured in the enclosure with six screws (not included).

The screws have to be installed in the following order:

STEP 1: Two screws installed through the front base,

which includes the lower front strip installation.

The refrigerator is provided with a lower front strip

(shipped as a loose part). The front strip is to be attached

after the refrigerator is set into the cutout opening.

1. Install the lower front strip by sliding it under the

bottom hinge plates, as shown in FIG. 5.

The transport support at the rear of the refrigerator can

be removed if necessary for the installation of the refrig-

erator in the enclosure. (See figure above).

NOTE: DO NOT install the appliance directly on

carpeting. Carpeting must be removed or

protected by a metal or wood panel beneath

the appliance, which extends at least full

width and depth of the appliance.

Caution: Use care when installing the refrigerator. This

refrigerator is equipped with the latest vacuum insulated

panel technology. These insulating panels are located

on the Top, Back, Bottom, Sides and Doors of the refrig-

erator.

If the surface is punctured, loss of insulation will occur,

resulting in poor refrigerator performance.

NOTE: A wood strip must be in place across the upper

opening of the enclosure. The top frame of the refrigera-

tor will be anchored to the wood strip with screws, see

FIG. 10.

The refrigerator must be installed in a substantial enclo-

sure and must be level. When installing the refrigerator

in the enclosure, all areas within the recess in which the

refrigerator is installed must be sealed.

Make sure that there is a complete seal between the

front frame of the refrigerator and the top, sides and

bottom of the enclosure. A length of sealing strip is ap-

plied to the rear surface of the front frame for this pur-

pose, see FIG. 4. The sealing should provide a complete

isolation of the appliance’s combustion system from the

vehicle interior.

NOTE: Be careful not to damage the sealing strip when

the refrigerator is put in place.

FIG. 4

2. Secure the refrigerator and the lower front strip with

two screws: One screw through each hinge. See

FIG 6.

FIG. 5

FIG. 6

1 2 3 4 5 6 7 8 9 10 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Dometic NDA1402 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Dometic NDA1402