Dometic RH141LD Manuel d'utilisateur télécharger pdf (Page 6)

5. Using the appliance

To start the refrigerator connect the plug into a

properly earthed socket.

The cooling fins should show signs of cooling after

about 3 hours. The refrigerator needs about 6 hours

at normal ambient temperature to reach 6 °C in the

storage compartment.

5.1. Temperature regulation

The usual setting required is in the region of 2 to 3 on

the thermostat knob (Fig. 5), but this can vary with

conditions of load and installation. If it is found

necessary to change the setting, the knob can be

turned to a higher number to give a lower temperature,

or a lower number to give a higher temperature. The

effect of any adjustment can be checked by means of

a thermometer when the refrigerator has reached the

new temperature after some hours.

Setting the temperature control to position “0” must

be avoided. Position “0” of the temperature control

does not ensure that the device is free from voltage. If

you do not wish to use the refrigerator, unplug mains

plug from the socket. Namely if the temperatur control

stays in this position for longer time (a couple of

hours), the aggregate protection (CUC) switches the

unit off. You can restart the refrigerator by unplugging

and plugging in the mains plug.

5.2. Cooling unit control (CUC)

The electronic checks the function after every

defrosting period (every 24 hours) by measuring the

evaporator temperature drop. If it registers a problem

the refrigerator will shut down and stops cooling. If this

happens you should check whether the refrigerator

has been overloaded, that the door was properly

closed, that the cooling unit ventilation is correct and

that the refrigerator is levelled. After checking, unplug

the refrigerator at least for 10 seconds and plug it in

again. This resets the unit and it will function again. If

no sign of cooling there is a problem with the cooling

unit and you should contact Dometic service.

Figure 5.

6. ICE CUBES (if available)

Fill the ice tray to 4/5 with drinking water, and place

the ice tray on the ice-tray shelf. Wipe off any

excess water to prevent the ice tray from freezing to

the surface.

To speed up the making of ice cubes, turn the

thermostat to position 5 for a short while.

Remember to turn the dial to its normal setting

when the ice cubes are frozen.

To remove the cubes from the ice tray, hold it under

running water. The ice cubes can now be taken out

easily.

7. Useful suggestion

Do not overfill the appliance. Put warm foods and

drinks in the appliance only when they have cooled

down to room temperature. It is advisable to leave

some space between the products in the cabinet to

ensure efficient and even cooling. If the shelves are

packed too tightly there may be unacceptable

temperature variations.

8. Defrosting, cleaning and

maintenance

This frost-formation is kept back by the FUZZY

LOGIC system built into the appliance.

The first defrosting phase commences 39 hours

after the start and lasts for two hours.

After this, the device operates for 22 hours at a

time, followed by a defrosting period of 2 hours.

The frost will melt and the defrost water will run

through the drain tube from the drip channel into an

evaporating vessel located at the bottom rear of the

refrigerator. (Fig 6) The defrost water will evaporate

automatically into the circulating air and the vessel

will not need emptying.

To switch off the unit, turn the thermostat knob to

"0", disconnect the refrigerator from the electricity

supply and leave the cabinet door open. After

defrosting the cabinet interior should be wiped out

with a clean, damp cloth.

Figure 6.

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Dometic RH141LD Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Non Dometic RH141LD