Dometic RA140 Manuel d'utilisateur télécharger pdf (Page 6)

During installation, please ensure the mains plug

is accessible at all times.

5. Using the appliance

To start the refrigerator connect the plug to the socket

outlet and switch on the socket. The cooling fins should

show signs of cooling after about 3 hours.

The refrigerator needs about 6 hours at normal

ambient temperature to reach 6 °C in the storage

compartment.

5.1. Temperature regulation

The usual setting required is in the region of 2 to 3 on

the thermostat knob (Fig. 4), but this can vary with

conditions of load and installation. If it is found

necessary to alter the setting,the knob can be turned

to a higher number to produce a colder temperature,

or a lower number to produce a warmer temperature.

The effect of any adjustment can be checked by

means of the thermometer after leaving the

refrigerator operating for a further period to settle

down again.

6. Ice cubes

Fill the ice tray to 4/5 with drinking water, and place

the ice tray on the ice-tray shelf. Wipe off any excess

water to prevent the ice tray from freezing to the

surface.

To speed up the making of ice cubes, turn the

thermostat to position 5 for a short while. Remember

to turn the dial to its normal setting when the ice cubes

are frozen.

To remove the cubes from the ice tray, hold it under

running water. The ice cubes can now be taken out

easily.

7. Useful suggestion

Do not overfill the appliance. It is advisable to

leave some space between the products in the

cabinet to ensure efficient and even cooling. If the

shelves are packed too tightly there may be

unacceptable temperature variations.

8. Defrosting, cleaning and

maintenance

Frost will gradually form on the cooling surfaces

and it must not be allowed to become too thick

since it acts as an insulator and interferes with the

cooling.

This frost-formation is kept back by the FUZZY

LOGIC system built into the appliance by switching

off the unit for two hours in every 24 hours. The

frost will melt and the defrost water will run through

the drain tube from the drip channel into an

evaporating vessel located at the bottom rear of the

refrigerator. (Fig 5) The defrost water will evaporate

automatically into the circulating air and the vessel

will not need emptying manually.

If we want to switch off the unit, turn the thermostat

knob to "0", disconnect the refrigerator from the

electricity supply and leave the cabinet door open.

After defrosting the cabinet interior should be

wiped out with a clean, damp cloth.

9. Changing the lightbulb (If available)

If the lightbulb needs changing, pull out the plug

and proceed as follows:

Press the metal reflector to one side and draw the

lamp covering backwards. Replace the bulb and

push the covering back into place.

A new 10-watt bulb can be obtained at any service

shop.

10. Reversing the door hang (Fig. 6-7)

Lay the appliance on its back. Remove the 8

screws (1). Remove the door, together with the two

hinges (2), from the housing.

Remove the two cover caps (3) from the housing

and place them in the open hinge holes in the

Figure 4.

Figure 5.

Figure 6.

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Dometic RA140 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Non Dometic RA140