Dometic 57915.421 Instructions d'exploitation télécharger pdf (Page 11)

Note: The adhesive on insulation is extremelyNote: The adhesive on insulation is extremely

Note: The adhesive on insulation is extremely

sticky. Be sure part is located where desiredsticky. Be sure part is located where desired

sticky. Be sure part is located where desired

before pressing into place. We recommend pull-before pressing into place. We recommend pull-

before pressing into place. We recommend pull-

ing off part of backing paper, locating part anding off part of backing paper, locating part and

ing off part of backing paper, locating part and

then remove backing paper as insulation is pressedthen remove backing paper as insulation is pressed

then remove backing paper as insulation is pressed

into place.into place.

into place.

a. Excess width is intended to seal the divider plate

to the sides of the 14" opening, This is to prevent

cold discharge air from circulating into the Air

Conditioner return air opening.

b. If the insulation is too high, stick the excess height

of insulation to the Air Conditioner base pan. Note:

Do not cover up unit rating plate.

C.C.

INSTALLATION OF ELECTRONICINSTALLATION OF ELECTRONIC

INSTALLATION OF ELECTRONIC

CONTROL BOXCONTROL BOX

CONTROL BOX

NOTE: If your installation includes the optional Elec-NOTE: If your installation includes the optional Elec-

NOTE: If your installation includes the optional Elec-

tric Heat Kit, install it at this time. This optional Heat Kittric Heat Kit, install it at this time. This optional Heat Kit

tric Heat Kit, install it at this time. This optional Heat Kit

is approved for use on 590 Series Air Conditionersis approved for use on 590 Series Air Conditioners

is approved for use on 590 Series Air Conditioners

only. Follow the instructions with the heat package foronly. Follow the instructions with the heat package for

only. Follow the instructions with the heat package for

its installation procedure.its installation procedure.

its installation procedure.

Place insulation in position

(Do not Cover unit rating plate)

Freeze Control with

wires to the right side

Coil

Return

Bend

Remove

Hang

Tag

1) Terminate the 4-conductor telephone cable(s)

protruding into the 14" roof opening. The cable(s)

must be terminated with a telephone RJ-11 con-

nector (Part No. ___________). Refer to the crimp

tool manufacturer for crimping instructions. En-

sure that the cable is installed into the connector

correctly before crimping. (See figure below).

2) Remove the screw holding the junction box cover

to the

A/C Control BoxA/C Control Box

A/C Control Box. Remove the cover.

579 AND 590 SERIES579 AND 590 SERIES

579 AND 590 SERIES

1) Snap the

Freeze Control SensorFreeze Control Sensor

Freeze Control Sensor (Part No.

3106480.001) onto the return bend of the evapo-

rator coil. (See figure below).

a. Locate "D" shaped notch in the flange of the

evaporator coil.

b. Place the horseshoe end of the

Freeze ControlFreeze Control

Freeze Control

SensorSensor

Sensor through this notch and snap it onto the

return bend. When positioned correctly, the

control wires will be 90 degrees to the direction

of the coil fin surface.

2) Plug the unit electrical cord into the mating con-

nector on the

Electronic Control BoxElectronic Control Box

Electronic Control Box. These

connectors are polarized and will easily snap

together.

DO NOT FORCEDO NOT FORCE

DO NOT FORCE.

3) Plug the telephone cable(s) into the telephone

jack(s) visible on the side of the

Electronic Con-Electronic Con-

Electronic Con-

trol Boxtrol Box

trol Box. (It does not matter which one.)

4) Locate the

Electronic Control BoxElectronic Control Box

Electronic Control Box on the ceiling

template.

5) Drive two #10 x 3/8 blunt point phillips head screws

(provided in the parts package) through the ceiling

template into the holes in the

Electronic ControlElectronic Control

Electronic Control

BoxBox

Box to hold it in place.

1 2 ... 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Dometic 57915.421 Instructions d'exploitation Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes à chaleur Dometic 57915.421