Dometic RM 8401 Instructions d'exploitation télécharger pdf (Page 21)

21

Fig. 48

 The electrical installation must be in

accordance with the national regulations

of the respective countries.

 The connection cables must be routed in

a way to prevent contact with hot

components of the unit/burner or with

sharp edges.

 Changes to the internal electrical instal-

lation or the connection of other electri-

cal components (e.g. external fan) to the

internal wiring of the appliance will ren-

der the e1/ CE admittance as well as any

claims from warranty and product liabili-

ty void!

* Specialised personnel are accredited experts who are

able, by virtue of their training and knowledge, to vouch

for the correct installation.

4.9 Electrical installation

The electrical installation shall be carried

out by qualified personnel only.

WARNING!

4.9.1 Mains connection

 The power should be supplied by a pro-

perly grounded socket outlet or a groun-

ded non-detachable connection. Where

a socket outlet with mains supply is

used, the outlet must be freely accessi-

ble.

Should the connection cable be

damaged, have it replaced by Dometic

Cable cross sections and cable lengths :

Motorcaravan & Caravan (inside)

4 mm

²

(RML 8xxx = 6 mm

²

)< 6 m

6 mm

²

(RML 8xxx = 10 mm

²

)> 6 m

Caravan (outside)

min 2,5 mm

²

2,5mm²

The refrigerator must be equipped with a gas

cock in the supply line to allow the supply to

be disconnected. Such a cut-out device must

be readily accessible to the user.

When using LPG gas (tank), please consider

that the burner needs cleaning at shorter inter-

vals due to the gas combustion method (2 - 3

times per year recommended).

Installation

4.9.2 Battery connection

The machine's 12V connection cable is con-

nected (observing correct polarity) to a termi-

nal strip (RMx 8xx0) or plug-in-cotacts (RMx

8xx1, 8xx5). The wiring for the 12V heating

element (refer to A, B wiring diagram connec-

tions) must be direct and by the shortest pos-

sible route to the battery or electric generator.

Provide a 20 A fuse to protect on-board 12V

circuit.

In order to ensure that the 12V power supply is

shut off when stopping the engine (otherwise

the battery would discharge within a few

hours), perform the power supply to the 12V

heating element (connection A/B in wiring dia-

gram) in a way to have the 12V supply only live

while the vehicle ignition is switched on.

The connection C/D (interior light, electronics)

must be permanently provided by a 12V DC

power supply to be protected by a 2A fuse.

If the appliance is installed in a caravan

the respective leads for the 12V+ and 12V-

connections A/B and C/D must not be

connected to each other on the caravan-

side (EN 1648-1).

CAUTION!

Customer Services or by qualified per-

sonnel to avoid hazards.

We recommend leading the power supply via

a board-side fuse protection.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire