6
2. Secure the refrigerator and the lower front strip with
two screws: One screw through each hinge. See
FIG 6.
Step 2: Two screws installed in the top frame.
The top decoration panel must be removed from the re-
frigerator before the screws can be installed.
Open the doors and remove the four screws that secure
the top decoration panel to the top frame. Two screws
are accessible from underneath see FIG. 7, the second
two screws that secure the decoration panel to the front
frame are located on each side of the lock retainer.
Carefully tilt the top decoration panel and lift up to re-
move from top frame. Be careful not to damage the cir-
cuit board and wires.
Any space between the counter, storage area or ceiling
and top of the refrigerator greater den 1-1/2 inches should
be blocked. The heat produced at the rear of the refrig-
erator will become trapped in this space, making the top
of the refrigerator hot and reduce the efficiency of the
refrigerator.
Drain water hose
A hole must be drilled through flooring see FIG. 8.
The hole must be drilled in the cut out opening of the
base plate at the rear of the refrigerator. The installer
MUST make sure that the hose does not kink when run
through the floor. Seal around the hose that goes through
the drilled hole. If a longer hose than supplied is required
to get the water to drain outside of the vehicle, the in-
staller will have to supply the extra length of hose.
TESTING LP GAS SAFETY
SHUTOFF
The gas safety shutoff must be tested after the re-
frigerator is connected to LP gas supply.
To test the gas safety shutoff, proceed as follows:
1. Start the refrigerator according to the instructions,
and switch to GAS mode. (See start up instruc-
tions).
2. Check that the gas flame is lit and the GAS mode
indicator lamp (C) is on.
3. Close the manual gas shutoff valve at the back of
the refrigerator. (See FIG. 1).
4. Wait for one minute. The CHECK indicator lamp
(D) should be on and the GAS mode indicator lamp
(C) should be off.
5. Remove protection cover (see FIG. 1) and open
the manual gas shutoff valve. Do not change any
button positions on the control panel. Apply a
noncorrosive commercial bubble solution to the
burner jet orifice.
6. No bubbles should appear at the opening of the
burner jet orifice. The presence of bubbles indi-
cates a defective gas safety shutoff, and service is
required.
7. If no bubbles were present at the burner jet orifice,
it should be rinsed with fresh water. Be careful not
to damage the burner jet orifice. Replace cover and
press the main power ON/OFF button (1) OFF and
back ON. Normal operation of the burner should
return. Allow the burner to operate for a minimum
of five minutes.
Install the two screws in the top frame, the holes are
accessible from underneath.
Seal the opening for the screws with aluminum tape.
Replace the top decoration panel with its four screws.
Be careful not to pinch the wires behind the panel.
STEP 3: Two screws installed in the rear base.
See FIG. 8.
Failure to follow the sequence in securing refrigerator in
enclosure can cause leakage between the frame and
cabinet.
FIG. 7
Hole for drain
water hose
FIG. 8FIG. 5
FIG. 6
(28 pages)
(40 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels