Dometic VT2500 Manuel d'utilisateur télécharger pdf

Display panel

First check whether:

 the cassette has been inserted correctly

 the vehicle water tank has been filled

 the power supply has been switched on (main switch).

Once the power supply for the vehicle has been switched on, the toilet is also auto-

matically switched on and a vacuum is produced in the system for the first time.

The yellow LED illuminates on the display panel.

After approx. 1 minute this procedure is finished. The green LED illuminates.

By lifting the pedal allow a little water to enter the toilet, so that the closure

on the base of the receptacle is covered.

Repeat this procedure after each flushing.

If the cassette is full or it is removed, the red LED illuminates and the pump is

switched off.

It cannot be used further until the cassette has been emptied or it is

inserted again.

Flushing the toilet

To flush, press the pedal down on the left side of the toilet. During the flushing

process close the seat lid; this will considerably reduce the noise.

The toilet may only be flushed whilst the green LED is illuminated.

In order to be able to use the toilet as often as possible for one cassette filling,

please economize on the water and paper. Normally approx. 0.4 L water are suffi-

cient for flushing once.

SSHHOORRTT IINNSSTTRRUUCCTTIIOONNSS

VACUUM-TOILET

for Caravan and Motorhomes

VT 2500

GELB (pump is running )

TOILET CANNOT BE USED

GREEN (ready)

RED (Cassette full or casset-

te removed)

TOILET CANNOT BE USED

LED

The system is ready for operation!

242 6001 - 82

1 2

Résumé du contenu

Page 1 - VT 2500

Display panelFirst check whether: the cassette has been inserted correctly the vehicle water tank has been filled the power supply has been switche

Page 2 - Cleaning

Only use commercially available toilet paper with 2 layers.Since the system always operates under a vacuum and is closedhermetically, no smell can dev